Products

Aplus 88: Tile On Tile Adhesive

Mortar for easy tile-on-tile application.

Aplus 88 Tile on Tile Adhesive is a mortar for tile-on tile application, both floor and wall, without removing the existing tile. This product provides high adhesion strength.

Reference Standard: EN 12004:2001

Advantage:

  • Easy to use, simply by adding water.
  • Economical and efficient because ceramic or homogenous tile can be applied without removing the existing tile.
  • Can be used for tiling granite / homogenous tile, marble, and natural stone.
  • Prevent popping tile.
  • Interior and exterior use.
  • Can be used for dry, wet, and submerged areas.

Discover more solutions from Aplus for your building needs.

  • Coverage area: ± 5 m2 / 3 mm thick
  • Packaging: 25 kg
  • Water requirement: 5.0 – 6.0 liters / 25 kg

  1. Ensure the surface for tile installation is level and stable
  2. Clean the surface from dust and dirt using water
  3. Pour 5–6 liters of water into a container
  4. Add Aplus Tile on Tile Adhesive 88 (25 kg) into the container with water
  5. Mix the solution thoroughly using a hand mixer
  6. Apply the mortar to the surface for tile installation and spread evenly with a flat trowel
  7. Level the mixture using a notched trowel at a 45˚ angle
  8. Apply a thin and even layer of mortar to the cleaned back side of the tile. For large tiles, the ‘Back Buttering’ method is recommended
  9. Place the tile on the wet mortar, adjust its position, and use tile spacers to ensure even grout lines
  10. The recommended adhesive layer thickness is 2–10 mm, depending on the flatness of the substrate surface
  11. Tap the tile with a rubber mallet to ensure proper adhesion and a level surface
  12. Clean the tile joints from excess mortar using a grout remover
  13. Proceed with tile grout application