Products

Aplus 10: Tile Adhesive

The right solution for tiling tiles to the floor and wall.

Aplus 10 Tile Adhesive is a mortar that serves as a tile adhesive for floor and wall.

Reference Standard: EN 12004:2001

Advantage:

  • High adhesion and plasticity when used.
  • Suitable for tiles with > 0.5 % water absorption.
  • Resistant to expansive and shrinkage.
  • It can be used for ubin/tegel.

  • Prevent popping tile.

Discover more solutions from Aplus for your building needs.

  • Coverage area: ± 5 m2 / 3 mm thick
  • Packaging: 25 kg
  • Water requirement: 5.0 – 6.0 liters / 25 kg

  1. Ensure the surface for tile installation is level and stable
  2. Clean the surface from dust and dirt using water
  3. Pour 5–6 liters of water into a container
  4. Add Aplus Tile Adhesive 10 (25 kg) into a container filled with water
  5. Mix the solution thoroughly using a hand mixer
  6. Apply the mortar mixture thinly using the flat side of the trowel (roskam) onto the surface where the tiles will be installed
  7. Reapply the mortar onto the surface where the tiles will be installed, leveling the mixture with a notched trowel at a 45˚ angle
  8. Install the tiles onto the wet mortar, adjusting their position with tile spacers to ensure even grout lines
  9. The recommended adhesive layer thickness is 2–10 mm, depending on the flatness of the substrate surface
  10. Next, tap the tiles with a rubber mallet to ensure proper adhesion
  11. Clean the tile joints from excess mortar using a grout remover
  12. Proceed with tile grout installation